Applying Chemical EOR on the Norne Field C-Segment

Applying Chemical EOR on the Norne Field C-Segment

This page is a publication and represents journal papers, conference papers and proceedings etc.

0
No votes yet

users have rated this content. We would love to have your vote as well. Log in and rate!



The world energy demand will grow and oil will continue to be a major part of the energy consumption. Enhanced Oil Recovery will play a key role in meeting the oil demand by increasing the low oil recovery factors in the world today. Half of the oil is still trapped in the reservoir after the production have ceased. The development of new technology has brought a renewed attention for chemical flooding. It has been recognized as a technically feasible method in the Norwegian Continental Shelf and is expected to become attractive.
Content

Norne C-Segment is a good candidate for chemical flooding based on screening, current drainage strategy and high water cut. The objects of this Master Thesis are to find an optimum chemical flooding strategy for the Norne C-Segment to maximise the profit from volume of incremental oil produced. The result of the project is based on Net Present Value calculation. Simulations are run in Eclipse on a simulation model of Norne C-Segment released by Center of Integrated Operations at NTNU and Statoil ASA. The model was not perfect history matched therefore an effort to look at the uncertainties in vertical barriers where done before applying chemicals.

The Ile formation was chosen as the target formation because of the highest OIP and high oil saturation. A synthetic model of the target formation was build to optimize the chemical injection scheme. Based on the evaluation of the injection wells C-2H was best suited for chemical flooding. The chemicals applied are polymer, surfactant, alkaline and combinations of two or all of these chemicals. Surfactant and alkaline are primarily used to reduce oil-water Interfacial Tension and minimize the capillary forces that trap residual oil after waterflooding. Polymers are used as a mobility control to improve reservoir contact and flood efficiency.

Based on the simulation results and economic evaluation polymer flooding is the best chemical flooding method with a net present value of 406 million USD in 2022. Norne C Segment Ile formation is favourable for mobility control. Surfactant and alkaline cannot mobilize enough residual oil to pay of the cost of chemicals and is not economical attractive.

Other key information

204 results
Below, you will find related content (content tagged with same topic(s) as this publication)
Content type: Publication

Generalized Travel-Time Inversion on Unstructured Grids

This is a scientific publication written in collaboration with the IO Center.

0
Content type: Publication

Global Stabilization of The Generalized Burgers-Korteweg-de Vries Equation by Boundary Control

This is a scientific publication written in collaboration with the IO Center

0
Content type: Publication

Gradient-based Methods for Production Optimization of Oil Reservoirs

This is a PhD thesis written at the Department of Engineering Cybernetics, Norwegian University of Science and Technology.

0
Content type: Tools and methods

Implementation of pressure prediction and problem detection in drilling

Matlab implementations with the ability to connect to SiteCom servers

0
Content type: Publication

Improved Geometrical Spreading Approximation in Layered Transversely Isotropic Media

This is a scientific publication written in collaboration with the IO Center.

0
Content type: Topic page

Integrated downhole seismics

Phase one of the IO center ran a successful study on downhole seismics and full waveform inversion. We here give an account of the results.

0
Content type: Publication

Integrated Field Modeling and Optimization

This is a PhD thesis written at the Department of Engineering Cybernetics, Norwegian University of Science and Technology.

0
Content type: Ongoing activity

Integrated modeling and optimization

This work shows how its is possible to integrate models along the value chain till facilities.

0
Content type: Publication

Integrated production optimization of oil fields with pressure and routing constraints: The Urucu field

This is scientific publications written in collaboration with the IO Center

5

Pages